Lynx Power Burner Insulated Jacket - LIJPB

This Lynx Insulated Jacket for the Power Burner is required for installations where the gas grill will be installed in combustible cabinets.

Combustible Materials

The following are considered combustible materials:

• Wood - it burns
• Drywall, Plasterboard, Wallboard, Gypsum Board, Sheetrock - Fire resistance rated, not fireproof or non-combustible due to paper backing
• WonderBoard, Backer Board, Durock, HardiBoard, Cement board - Flammability rating of 0 but have no insulation quality
• Granite, Marble, Tile - will not burn but have no insulation quality

Lynx Insulated Jackets require a full deck or a ledge on each side to support it. An LIJ will sit flush with the countertop. They include holes for the gas and electrical lines.

Note: Never under any circumstance should you install the transformer or run a quick disconnect hose in between the grill and the inside of the insulating jacket.

• Take lines from the grill out of the jacket via the shortest route. Do not coil hose or wire behind the grill inside the jacket.
• 4” square holes for gas and electrical connections (rear or bottom access).  Make these holes in the frame based on your requirements
• Use ¾” metal flex line if needed, not rubber or plastic 
• Install transformer well under grill in island, not directly behind it or below it.

Delivery times depend on location. You must be present to accept delivery. Curb Side Delivery Only. Shipping prices are for with-in the Continental United States (Contiguous USA). Shipments to Alaska Hawaii and Puerto Rico require additional charges. All other countries and US Territories are considered International for which there is an additional charges.
Ships via Freight